Rear Seat Replacement (Avalanche/Escalade EXT)

Fig 1: View Of Rear Seat Assembly & Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the jack access cover and jack from the vehicle. Remove the rear seat track finish cover.
1	Rear Seat Assembly Nut (Qty: 7) NOTE: Refer to Fastener Notice . Tip: Remove the adjuster cover to access the nuts. Tighten: 45 N.m (33 lb ft)
2	Rear Seat Belt Buckle Anchor Nut Tip: The nut is located behind the seat. Tighten: 45 N.m (33 lb ft)
3	Rear Seat Assembly Procedure: Disconnect the electrical connector, if equipped.