Circuit Description
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
The TAP Shift system allows the driver to manually shift gears by using the TAP Shift switches located on the automatic transmission shift lever. Pushing the shifter handle forward will command an upshift and pulling the shifter handle back will command a downshift. The TAP Shift system is activated when the gear selector is in the manual (M) position and is deactivated in all other positions.
TAP Shift Circuit Performance
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 |
|
- | Go to Diagnostic Trouble Code (DTC) List/Type | Go to Step 2 |
| 2 |
|
- | Go to Step 3 | Go to Step 8 |
| 3 |
|
- | Go to Step 6 | Go to Step 4 |
| 4 | Using the J 39200
DMM and the J 35616
GM terminal test kit, measure the voltage between the TAP Up/TAP Down enable signal circuit and a known good ground at the AT shift lever connector. Does the voltage measure near the specified voltage? |
12 V | Go to Step 5 | Go to Step 9 |
| 5 | Using the J 39200
DMM and the J 35616
GM terminal test kit, measure the voltage between the TAP Up/TAP Down enable signal circuit and the TAP Up/TAP Down ground circuit at the AT shift lever connector. Does the voltage measure near the specified voltage? |
12 V | Go to Step 11 | Go to Step 10 |
| 6 |
|
- | Go to Step 7 | Go to Step 11 |
| 7 | While observing the scan tool, move the AT shift lever in the downshift position. Does the Driver Shift Request parameter display downshift? |
- | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 11 |
| 8 | Test the Driver Shift Control enable signal circuit for a short to ground. Refer to Testing for Short to Ground
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 12 |
| 9 | Test the Driver Shift Control enable signal circuit for an open. Refer to Testing for Continuity
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 12 |
| 10 | Test the Driver Shift Control ground circuit for an open. Refer to Testing for Continuity
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 13 | - |
| 11 | Replace the floor shift control. Refer to Automatic Transmission Control Replacement (Left Hand Drive)
or Automatic Transmission Control Replacement (Right Hand Drive)
. Did you complete the replacement? |
- | Go to Step 13 | - |
| 12 | Replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement (Left Hand Drive)
or Instrument Cluster Replacement (Right Hand Drive)
. Did you complete the replacement? |
- | Go to Step 13 | - |
| 13 | Perform the following procedure in order to verify the repair:
Do the Driver Shift Control and the Driver Shift Request parameters indicate the proper display? |
- | System OK | Go to Step 1 |