LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (GNC) >> Installation Procedure

Installation Procedure

    Fig 1: Stabilizer Shaft Assembly
    GM2018661Courtesy of GENERAL MOTORS COMPANY
  1. Install the insulator (3), the bracket (2), on the stabilizer shaft (4).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the NEW bolts (1) and tighten to:
    • First Pass: 22 N.m (16 lb ft).
    • Final Pass: plus 30 degrees.
    3. Fig 2: Stabilizer Shaft & Stabilizer Shaft Link
    GM2018660Courtesy of GENERAL MOTORS COMPANY
  3. Install the stabilizer shaft (1) to stabilizer shaft link (2). Refer to Stabilizer Shaft Link Replacement (GNC) .
  4. Raise the rear support back into position.
    5. Fig 3: Identifying Support Mounting Bolts
    GM2013226Courtesy of GENERAL MOTORS COMPANY
  5. Install the rear support bolts (1). Refer to Rear Suspension Support Replacement (GNC) .
  6. Install the lower shock absorber mounting bolts. Refer to Shock Absorber Replacement (GNC) .
  7. Install the rear brake callipers. Refer to Rear Brake Caliper Replacement .
  8. Install the rear suspension control arm bolts to the body. Refer to Rear Suspension Control Arm Replacement .
  9. Install the rear springs. Refer to Rear Spring, Insulator, and Jounce Bumper Replacement .
  10. Remove the adjustable jack stands from the rear support.
  11. Install the park brake cables on the rear suspension support. Refer to Parking Brake Rear Cable Replacement .
  12. Install the rear muffler assembly. Refer to Exhaust Muffler Replacement (Single) or Exhaust Muffler Replacement (Dual) .
  13. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  14. Lower the vehicle.
scientia non olet · About LEMON Manuals