LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Front Seat Outboard Seat Back Airbag Replacement >> Removal Procedures

Removal Procedures

    WARNING:

    Refer to SIR Warning .

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove driver or passenger seat adjuster finish cover. Refer to Driver or Passenger Seat Adjuster Finish Cover Replacement .
  3. Remove driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) .
  4. Remove front seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement (without AHS) .
  5. Remove front seat head restraint guide bezel. Refer to Front Seat Head Restraint Guide Bezel Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) or Front Seat Head Restraint Guide Bezel Replacement (8-Way Power) .
  6. Remove the front seat head restraint adjust rod guide. Refer to Front Seat Head Restraint Guide Replacement .
    7. Fig 1: Recliner Control Shaft And Securing Clip
    GM2019884Courtesy of GENERAL MOTORS COMPANY
  7. Clip out securing (1) of recliner control shaft (2).
    8. Fig 2: Recliner Control, Shaft And Cushion Strap
    GM2019885Courtesy of GENERAL MOTORS COMPANY
  8. Remove recliner control (1) from recliner shaft (2). Unhinge the cushion strap (3) at seat frame.
    9. Fig 3: Front Seat Back Cushion And Backrest Frame
    GM2019883Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    For loosening move the cushion upper and pull from backrest frame.

  9. Loose the front seat back cushion at backrest left side (1) and right side (2).
  10. Clip out the front seat back cushion vent fan mat (3) of vent fan (4). Pull the cushion (5) in front to surface.
    11. Fig 4: Seat Side Inflatable Restraint Module And Nuts
    GM2019886Courtesy of GENERAL MOTORS COMPANY
  11. Loosen both nuts (1, 2) from seat side inflatable restraint module (3).
    12. Fig 5: Wiring Harness Connector And From Seat Side Inflatable Restraint Module
    GM2019887Courtesy of GENERAL MOTORS COMPANY
  12. Disconnect the wiring harness connector (2) from seat side inflatable restraint module (1).
    13. Fig 6: Wiring Harness Connector And Seat Back Cushion Heater
    GM2019889Courtesy of GENERAL MOTORS COMPANY
  13. Disconnect wiring harness connector (1) of the seat back cushion heater.
    14. Fig 7: Front Seat Back Cushion With Cushion Pad And Backrest Frame
    GM2019888Courtesy of GENERAL MOTORS COMPANY
  14. Remove front seat back cushion with cushion Pad (1) from backrest frame (2).
    15. Fig 8: Seat Side Inflatable Restraint Module And Textile Straps
    GM2019890Courtesy of GENERAL MOTORS COMPANY
  15. Remove seat side inflatable restraint module (1) out of the textile straps (2).
scientia non olet · About LEMON Manuals