LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Front Seat Outboard Seat Back Airbag Replacement >> Installation Procedures

Installation Procedures

    Fig 1: Seat Side Inflatable Restraint Module And Textile Straps
    GM2019890Courtesy of GENERAL MOTORS COMPANY
  1. Install seat side inflatable restraint module (1) at cushion cover with the textile straps (2).
    2. Fig 2: Front Seat Back Cushion With Cushion Pad And Backrest Frame
    GM2019888Courtesy of GENERAL MOTORS COMPANY
  2. Install front seat back cushion with cushion pad (1) at the backrest frame (2).
    3. Fig 3: Wiring Harness Connector And Seat Back Cushion Heater
    GM2019889Courtesy of GENERAL MOTORS COMPANY
  3. Connect the wiring harness connector (1) of the seat back cushion heater.
    4. Fig 4: Wiring Harness Connector And From Seat Side Inflatable Restraint Module
    GM2019887Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Proof the correct locking of wiring harness connector (2).

  4. Connect the wiring harness connector (2) from seat side inflatable restraint module (1).
    5. Fig 5: Seat Side Inflatable Restraint Module And Nuts
    GM2019886Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  5. Position seat side inflatable restraint module (3) the backrest frame. Screw both nuts (1, 2) from seat side inflatable restraint module (3) and tighten to 3.25 N.m (29 lb in).
    6. Fig 6: Front Seat Back Cushion And Backrest Frame
    GM2019883Courtesy of GENERAL MOTORS COMPANY
  6. Clip in the front seat back cushion vent fan mat (3) at the vent fan (4). Position the cushion (5).
  7. Install front seat back cushion at backrest left side (1) and right side (2).
  8. Install the front seat head restraint adjust rod guide. Refer to Front Seat Head Restraint Guide Replacement .
  9. Install the front seat head restraint guide bezel. Refer to Front Seat Head Restraint Guide Bezel Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) or Front Seat Head Restraint Guide Bezel Replacement (8-Way Power) .
  10. Install the front seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement (without AHS) .
  11. Close the cushion at backrest rear side.
  12. Install the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) .
  13. Install the driver or passenger seat adjuster finish cover. Refer to Driver or Passenger Seat Adjuster Finish Cover Replacement .
scientia non olet · About LEMON Manuals