LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery box. Refer to Battery Tray Replacement .
  2. Prior to removing the mount, mark mount to transmission, mount to body interfaces and fasteners to mount interfaces using spray paint or a marker for correct positioning during installation.
  3. Install the engine support fixture. Refer to Engine Support Fixture , for the 2.0L engine or Engine Support Fixture for the 2.4L engine .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    5. Fig 1: Identifying Front Transmission Mount Through Bolt
    GM2199369Courtesy of GENERAL MOTORS COMPANY
  5. Remove the front transmission mount through bolt (1).
    6. Fig 2: Rear Transmission Mount Through Bolt
    GM2199347Courtesy of GENERAL MOTORS COMPANY
  6. Remove the rear transmission mount through bolt (1).
  7. Lower the vehicle.
    8. Fig 3: Transmission Mount To Transmission Bolts
    GM1875678Courtesy of GENERAL MOTORS COMPANY
  8. Remove the transmission mount to transmission bolts.
    9. Fig 4: Transmission Mount To Frame Rail Bolts
    GM1884332Courtesy of GENERAL MOTORS COMPANY
  9. Using the engine support, lower the transmission enough to provide clearance for the left transmission mount.
  10. Remove the transmission mount to frame rail bolts (2).
  11. Remove the left transmission mount (1).
scientia non olet · About LEMON Manuals