Installing the rear shock absorber

Check the centering plate (1) for damage, replace if necessary.
Check the position of centering plate (1) and, if necessary, correct it.

Courtesy of BMW OF NORTH AMERICA, INC.
Compress the shock absorber (1) and feed it into the wheel well.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Replace the nut (1) and the screw (2).
Parts: Nut, bolt
Insert the screw (2).
Tighten the nut (1) hand-tight.
The screw connection is tightened with the torque wrench later in the NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.
WARNING:
Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!
- Secure the vehicle hoist against lowering and lifting.
- Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.
Courtesy of BMW OF NORTH AMERICA, INC.
Position special tool 2 219 012 with special tools 2 411683 and 2 305 379 under wheel carrier (1).
Lift the wheel carrier slightly using special tool 2 219 012 . Position the shock absorber on the body in the process.
Do not press against the spring force of the coil spring.
Replace screws (1).
Parts: Screws

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Nut and locknut/self-locking nut
M8x40 Replace screws.	tightening torque	28 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect the special tool 2 219 012 and set it aside.
NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Attach all the cables to holder (2).
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work