Installing the housing coyer
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the housing cover on the rear axle differential.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Lid to rear axle differential M12 Tightening torque 140 Nm M10 Tightening torque 90 Nm
Follow-up work
- Refer to LIFTING THE REAR AXLE DIFFERENTIAL .
- Refer to CHECK/TOPPING UP OIL LEVEL IN THE REAR AXLE DIFFERENTIAL .
- Refer to ATTACHING THE CENTRAL MOUNT OF THE PROP SHAFT .
- Refer to FASTENING THE WIRING HARNESS TO THE M SPORT DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .