Lifting rear axle support
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Lift the rear axle support with the special tools 2 219 012 and 0 495 817 (31 5 251) and position it on the body.
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear axle carrier to body | ||
| M12 Replace screw. | Tightening torque | b 108 Nm |
- Lower the special tool 0 495 817 (31 5 251) with the special tool 2 219 012 and place it to the side.
Follow-up work
- Refer to ATTACHING THE CENTRAL MOUNT OF THE PROP SHAFT .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE LEFT AND RIGHT THRUST FIELD .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to SECURING THE CABLE TO THE REAR AXLE SUPPORT .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .