Installing the feed line for the transmission oil cooler

Feed line for the transmission oil cooler 

Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully  feed in and install the feed line (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace sealing ring (1)  of feed line (2)  .

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the feed line (1)  .
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed the feed line (1)  on the holder (2)  in the arrow direction and install it.

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the feed line (2)  .
• Press the lock (1)  in the arrow direction and lock the feed line (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the feed line (1)  in the holder (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the holder (2)  .

  The lock (1)  must engage audibly.

• Close the rubber retainer (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.

  The connector (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach holder (1)  to the electrical auxiliary coolant pump (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the electrical auxiliary coolant pump (2)  .
• Tighten nut (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING FAN COWL .
• Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
• Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING THE INTAKE FILTER HOUSING ON THE LEFT (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 1 TO 3 .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to SECURING THE UNIVERSAL JOINT ON THE STEERING GEAR .
• Refer to INSTALLING FRONT PROPELLER SHAFT AT THE FRONT AXLE TRANSMISSION .
• Refer to INSTALLING THE INTERMEDIATE PIPE .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
• Refer to INSTALLING THE BOTTOM FRONT RIGHT SIDE COVER .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT SPOILER .