Installing air conditioning compressor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Push transmission oil thermostat (2) slightly to the side.
- Feed in and position the air conditioning compressor (1)
from bottom to top.
- Connect plug connection (1)
and lock.
- Position the refrigerant lines (2) on the air conditioning compressor (3) .
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line on air conditioning compressor | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Feed bearing bracket (1) in from below and place on crankcase (3) .
- Tighten screws (2) on bearing bracket (1) .
TIGHTENING TORQUES SPECIFICATION
| Air conditioning compressor bearing bracket to crankcase | ||
|---|---|---|
| Screw | tightening torque | 25 Nm |
- Correctly position air conditioning compressor (2) .
- Tighten screws (1) on the air conditioning compressor (2) .
TIGHTENING TORQUES SPECIFICATION
| Air conditioning compressor to holder/engine | ||
|---|---|---|
| M8 | tightening torque | 22 Nm |
- Tighten screw (1) as shown.
TIGHTENING TORQUES SPECIFICATION
| Air conditioning compressor to holder/engine | ||
|---|---|---|
| M8 | tightening torque | 22 Nm |
- Clip the transmission oil thermostat (1) downwards into the decoupling element (2) on front subframe.
Follow-up work
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to FASTENING ANTI-ROLL BAR ON FRONT AXLE SUPPORT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to SECURING THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to EVACUATING AND CHARGING CONDITIONING .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to RUNNING IN THE NEW AIR CONDITIONING COMPRESSOR .