Fastening anti-roll bar on front axle support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Correctly position the anti-roll bar (3) .
- Make sure that the retainers for the anti-roll bar and the upper sections of the holder are positioned correctly.
- Replace screws (1)
and (2)
.
Parts: Screws
NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position. - Tighten down screws (1)
and (2)
.
The screws have different lengths.
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |
TIGHTENING TORQUES SPECIFICATION
| Holder, stabilizer mounting to front axle support | ||
| M12 Replace screw. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |