Install the backrest cover of the rear seat backrest
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the backrest cover on the cushion.
- Secure all trim wires with clamps.
- Replace the clamps (2).
Parts: Clamps
- Insert the clamp (2) with the special tool 0 492 668 (52 0 050) .
- Clasp the trim wire (3) of the cushion (1) and the trim wire (4) of the backrest covering with the clamp (2) and bend the clamp (2).
Follow-up work
- Refer to INSTALLING THE BACKREST FRAME FOR THE REAR SEAT BACKREST ON THE LEFT .
- Refer to INSTALLING THE REAR PANEL ON THE REAR SEAT BACKREST .
- Refer to INSTALLING THE GUIDE SLEEVE FOR THE REAR HEAD RESTRAINT .
- Refer to INSTALLING THE HEAD RESTRAINT .
- Refer to INSTALLING THE CENTER REAR SEAT BACKREST .
- Refer to INSTALLING THE LEFT AND CENTER REAR SEAT BACKREST .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE REAR SEAT BACKREST .
- Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .