Lower roofliner
NOTE:
RISK OF DAMAGE
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
- Guide the headlining past the parapet of the right C-/D-pillar by bending slightly and place it down slowly on the positioned head restraint.
NOTE:
TECHNICAL INFORMATION
If damage is found on the speaker or the speaker cover, the entire headliner must be replaced.
If damage is found on the speaker or the speaker cover, the entire headliner must be replaced.
Preliminary work
- Refer to REMOVING THE SIDE COVER ON THE LEFT AND RIGHT DASHBOARD .
- Refer to REMOVING THE CENTER A-PILLAR TRIM PANEL AT LEFT AND RIGHT .
- Refer to REMOVING THE LEFT AND RIGHT A-PILLAR TRIM PANEL .
- Refer to REMOVING THE SUN VISOR WITH THE COUNTER BEARING ON THE LEFT AND RIGHT .
- Refer to REMOVING THE FRONT VANITY MIRROR LIGHT .
- Refer to PARTIALLY REMOVING THE COVER FOR THE INTERIOR MIRROR .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to PARTIALLY REMOVING THE B-PILLAR TRIM PANEL ON THE TOP LEFT AND RIGHT .
- Refer to REMOVING THE LEFT AND RIGHT BACKREST SIDE SECTIONS WITH THE AIRBAG .
- Refer to REMOVING THE RIGHT AND LEFT LUGGAGE COMPARTMENT SIDE SHELF COVER .
- Refer to REMOVING THE SEAT BELT FINISHER STRIP AT THE LEFT AND RIGHT .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING INTERIOR ROOF LIGHT .
- Refer to REMOVING THE COAT HOOK .
- Refer to REMOVING THE REAR WINDOW STORAGE SHELF AT FRONT .
- Refer to REMOVING HINGE COVER .
- Refer to REMOVING THE D-PILLAR TRIM PANEL .
Precondition
The front seats have been fully adjusted towards the bottom.
The front seat backrests have been fully adjusted towards the rear.
NOTE:
RISK OF DAMAGE
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
- Guide the headlining past the parapet of the right C-/D-pillar by bending slightly and place it down slowly on the positioned head restraint.
- Loosen screw (1) .
- Release headlining (2) downwards from the clips (3) .
- Unclip headlining (1) downwards from the clips (2) .
- Feed out the headlining (1) with a support person at the respective edge protection and place it on the seats.