Perform Flushing 2

• Start Flushing 2 on the A/C service station.
• Perform Flushing 2 for at least 30 minutes.

  Check 

• Once Flushing 2 is complete, check whether the refrigerant in the sight glass on the A/C service station is clean:

  Result 

  » Refrigerant in sight glass is clean.

  Measure

  • Both flushings are complete.

  Result 

  » Refrigerant in sight glass is not yet clean.

  Measure

  • Fully repeat Flushing 2.

Follow-up work 

• Refer to REMOVING ALL SPECIAL TOOLS .
• Refer to INSTALLING THE EXPANSION VALVE FOR THE HIGH-VOLTAGE BATTERY UNIT ON THE RIGHT .
• Refer to INSTALLING THE EXPANSION VALVE FOR THE HIGH-VOLTAGE BATTERY UNIT  .
• Refer to INSTALLING THE UNDERSHIELD (TANK COVER) AT RIGHT .
• Refer to INSTALLING THE LEFT UNDERSHIELD (TANK COVER) .
• Refer to INSTALLING FRONT CONNECTING SUPPORT ON TUNNEL .
• Refer to INSTALLING THE REFRIGERANT SHUTOFF VALVE FOR THE HIGH-VOLTAGE BATTERY .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING THE UNDERSHIELD ON THE SIDES .
• Refer to DISCONNECTING REFRIGERANT LINE ON THE CONNECTING PIECE .
• Refer to INSTALL EXPANSION VALVE .
• Refer to CONNECTING THE REFRIGERANT LINE TO THE EXPANSION VALVE .
• Refer to INSTALLING THE HOLDER FOR TENSION RELIEF OF THE CABLES .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE ELECTRIC A/C COMPRESSOR (EKK) .
• Refer to SECURING THE REFRIGERANT LINE TO THE CONNECTING PIECE .
• Refer to REMOVING THE LOW-TEMPERATURE COOLANT EXPANSION TANK .
• Refer to INSTALLING THE ENGINE CONTROL UNIT COVER .
• Refer to INSTALLING HOLDER FOR THE COOLANT LINES .
• Refer to INSTALLING THE TENSIONING PULLEY FOR THE COOLANT PUMP .
• Refer to INSTALLING THE DRIVE BELT FOR THE COOLANT PUMP .
• Refer to TIGHTENING BELT PULLEY .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING THE CLEAN AIR PIPE AND THE RESONATOR .
• Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
• Refer to INSTALLING AIR CONDITIONING CONDENSER .
• Refer to INSTALLING THE FRONT BOTTOM WHEEL ARCH COVER .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE BRACKET FOR THE DME CONTROL UNIT .
• Refer to INSTALLING THE ENGINE CONTROL UNIT COVER .
• Refer to EVACUATE AND CHARGE CONDITIONING .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to INSTALLING FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .