Install the rear top cross connection
- Feed in and position the rear top (3) cross connection.
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Rear cross connection at the top of the hood lock support | ||
|---|---|---|
| screw | Tightening torque | 19 Nm |
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear top cross connection to wheel arch carrier support | ||
|---|---|---|
| M10x35 screw | Tightening torque | 56 Nm |
- If fitted:
Position the resonator (2) and tighten the screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Resonator to rear top cross connection | ||
|---|---|---|
| M6x20 screw | tightening torque | 8 Nm |
- If fitted:
Position the resonator (2) and tighten the screws (1).
- Clip the vehicle wiring harness (1) onto the rear top cross connection (2).
Follow-up work