Insert top automatic air flap control
NOTE:
The operations shown only for one side must be carried out on both sides.
- Fitting the top air flap control (1) .
- Connect corresponding connectors and lock.
- Feed in the top air flap control (1)
and clip in with the ball head (2)
.
- Clip the top air flap control into the detents (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Air flap control on front end | ||
| Oval-head screw with spring washer | Tightening torque | 4.6 Nm |
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALL THE FRONT HOOD SEAL .