Install bumper cover, front
- Position front bumper cover.
- Clip the front bumper cover into the detents (1) .
NOTE:
Perform the steps on the left and right side.
- Connect connectors (1) and lock.
- If necessary, connect connectors (2) and lock.
NOTE:
Perform the steps on the left and right side.
- Feed the bumper cover in arrow direction into the guide and clip in with the detent (1) .
- Tighten screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Front bumper panel to fender | ||
|---|---|---|
| Torx screws 5x35 | Tightening torque | 3 Nm |
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Front bumper cover on underbody protection | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 2.6 Nm |
Follow-up work
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALL CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .