Install the support for the bumper cover

• Install the support (3)  for the bumper cover and tighten the nuts (2)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear bumper support to body
  Nut	Tightening torque	108 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear silencer to bumper bracket
  M8	tightening torque	19 Nm

• Install the adapter (3)  and mount the expanding rivets (2)  .
• Tighten the screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper panel, rear
  Hexagon screw	Tightening torque	3.0 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING THE RIGHT D-PILLAR TRIM PANEL .
• Refer to INSTALLING THE COVER OF THE RIGHT BELT FEED TRIM .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE BATTERY COVER .
• Refer to INSTALLING THE COVER OF THE SIDE MEMBER ON THE RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING THE STORAGE SHELF .