Install bumper cover, front

• Install the bumper cover (2) and engage in the detents in the area of the dashed line.
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Upper bumper cover on air flap control
  screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the left and right side.
• Clip the bumper cover (2) upwards into the detents.
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front bumper cover on side wall
  Hexagon screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the plug (1) into the left wheel well.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the plug (1) into the right wheel well.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Undershield/frame
  Hexagon screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT PART OF THE LEFT FRONT AND RIGHT WHEEL ARCH COVER (PARTIALLY REMOVED) .
• Refer to INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM (PARTIALLY REMOVED) .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .