Install charge air line
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Check sealing ring (1) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9 030) .
- Check sealing ring (2) on the charge air line (3) for damage, if necessary replace with the special tool 0 496 714 (00 9 030)
.
- Insert and install charge air line (4).
- Lock clamp (3).
The clamp (3) must engage audibly.
- Insert and install the coolant hose (2).
- Lock clamp (1).
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Charge air line to throttle valve M6x30 tightening torque 8 Nm - Connect connectors (2) and lock.
The connector (2) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Feed in and position auxiliary coolant pump (4).
- Feed in and position retaining bracket (3).
- Tighten nut (2).TIGHTENING TORQUE SPECIFICATIONS
Electric coolant pump to holder M6 tightening torque 8 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING THE CLEAN AIR PIPE AND THE RESONATOR .
- Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING ACOUSTIC COVER .