Installing the intake filter housing (tension strut removed on shock tower)
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
Precondition
The tension strut on the shock tower is removed.
- Check rubber mount (1)
for correct fit.
- Insert the intake filter housing (4) and engage in the rubber mounts.
- Tighten down screw (3)
.TIGHTENING TORQUES SPECIFICATION
Intake silencer housing to resonator TS5x20 Tightening torque 2.5 Nm - Connect and lock the connector (2)
of the hot film air mass meter.
The connector (2) must lock audibly.
- Tighten clamp (1)
.TIGHTENING TORQUES SPECIFICATION
Clean air pipe to upper section of intake filter housing cl. Tightening torque 3 Nm