Install the trim on the rear bumper panel
- Position the trim on the rear bumper panel (3) and engage into the detents (2) along the marked line.
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 2.5 Nm |
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING BOTH BOTTOM D-PILLAR TRIM PANELS .
- Refer to INSTALLING THE LEFT AND RIGHT FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL .