Removing the vibration damper
Preliminary work
- Deactivate the 48 v ELECTRICAL SYSTEM .
- Disconnect all battery GROUND LEADS .
- Remove the ACOUSTIC COVER .
- Remove the rear left and right engine compartment COVER PANEL .
- Remove the top right and left engine compartment COVER .
- Remove left and right hood gasket STAND .
- Remove the left and right FRONT-END STRUT .
- Remove front CROSS CONNECTION .
- Remove the rear top CROSS CONNECTION .
- Remove intake silencer HOUSING .
- Remove the front UNDERBODY PROTECTION .
- Remove the center UNDERBODY PROTECTION .
- Remove rear UNDERBODY PROTECTION .
- Remove STARTER MOTOR .
- Remove the FAN COWL .
- Remove clean AIR PIPE .
- Remove charge AIR LINE .
- Remove the starter motor generator DRIVE BELT .
- Position special tool 0 496 595 (11 6 130) and fasten with screw (1).
- Slide the counter support on the screw (2) toward the flywheel and turn the engine by the vibration damper until the gearing (3) engages the flywheel.
- Tighten the bolt (2).
- Remove screws (arrows).
- Guide the vibration damper (1) upward and remove it.