Remove charge air line
NOTE:
TECHNICAL INFORMATION
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
Preliminary work
- Remove the front UNDERBODY PROTECTION
- Remove the ACOUSTIC COVER
- Remove the top right and left engine compartment COVER
- Remove front CROSS CONNECTION
- Remove the left and right FRONT-END STRUT
- Remove intake silencer HOUSING
- Remove the rear left and right engine compartment COVER PANEL
- Remove left and right hood gasket STAND
- Remove the rear top CROSS CONNECTION
- Remove the FAN COWL
- Remove clean AIR PIPE
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Unlock plug connection (1) and disconnect.
- Loosen nut (2).
- Pull out and remove the retainer (3).
- Feed out auxiliary coolant pump (4) and set aside.
- Unlock plug connection (1) and disconnect.
- Unlock plug connection (2) and disconnect.
- Loosen screws (3).
- Unlock the clamp (1).
- Feed out the coolant hose (2) and set it aside.
- Unlock the clamp (3).
- Feed the charge air line (4) out to the top and remove.