Removing the front bumper cover support
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Preliminary work
- Refer to DEACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to REMOVING CENTER RADIATOR ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING BOTH WHEEL ARCH COVERS IN FRONT .
- Refer to PARTIALLY REMOVING TEMPERATURE SENSOR .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING TOPPING AIR DUCT .
- Refer to REMOVING PEDESTRIAN PROTECTION SENSOR .
- Refer to IF INSTALLED: REMOVING FRONT RADAR SENSOR (FRS) WITH BRACKET .
- Refer to REMOVING AIR DUCT AT THE BOTTOM .
- Refer to REMOVING THE LEFT AND RIGHT FANFARE HORN .
- Refer to REMOVING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to REMOVING STIFFENING STRUT .
- Refer to REMOVING THE SIDE AIR DUCT .
- Refer to PARTIALLY DETACHING THE WIRING HARNESS OF THE FRONT END .
- Refer to PARTIALLY REMOVING THE EXTERNAL RADIATOR AT LEFT AND RIGHT .
NOTE:
Perform the steps on the right and left side.
- Loosen screw (1) .
- Loosen screw (2) .
NOTE:
Perform the steps on the right and left side.
- Loosen screws (1) .
- Loosen screws (2) .
- Guide out the support for the bumper cover at front bottom (3) and remove it forwards.