Installing the swivel bearing
- Spread the swivel bearing (1) with the special tool 2 414 636 .
- Align the gap on the swivel bearing (1) correctly to the positioning pin on the spring strut (2).
- Slide the swivel bearing (1) in the arrow direction onto the spring strut (2) all the way to the stop.
- Remove the special tool 2 414 636
.
- Position holder (3) on the swivel bearing.
- Replace screw (2) and nut (1).
Parts: Screw, nut
- Insert screw (2) and guide on the nut (1).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATION
| Spring strut to swivel bearing | ||
|---|---|---|
| M10 Replace screw and nut. Tightening via screw. |
Tightening torque | 60 Nm |
| Angle of rotation | 180° | |
Follow-up work
- Refer to INSTALLING BRAKE GUARD PLATE, FRONT .
- Refer to ATTACHING THE WISHBONE ON THE SWIVEL BEARING .
- Refer to FASTENING THE WISHBONE ON THE FRONT AXLE SUPPORT .
- Refer to SECURING TENSION STRUT ON SWIVEL BEARING .
- Refer to SECURING THE TIE ROD ON THE SWIVEL BEARING .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL SPEED SENSOR .
- Refer to INSTALLING FRONT BRAKE DISC .
- Refer to FASTENING FRONT BRAKE CALIPER .
- Refer to ATTACHING FRONT BRAKE HOSE .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
- Refer to MEASURING THE RIDE HEIGHT OF THE FRONT AXLE AND ADJUSTING THE NORMAL POSITION .
- Refer to TIGHTENING THE SCREW CONNECTION OF THE WISHBONE ON THE FRONT SUBFRAME .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to PERFORM CHASSIS ALIGNMENT CHECK .