Fasten the wishbone on the front axle support

Release the screw (1). In doing so, counter support at the nut (2).
Replace screw (1) and nut (2).
Parts: Screw, nut
Insert screw (1) and guide on the nut (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
Hand-tighten the screw (1) with the standard tool (2) . In doing so, counter support at the nut (3) .
Standard tool: Pivoting extension 1/2 inch

Swivel extension 1/2 inch

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Swivel extension 1/2 inch

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Position the holder (1) of the attachment rod (2) for the ride height sensor on the wishbone (3) and lock it.

Courtesy of BMW OF NORTH AMERICA, INC.