Install the cover of the steering assembly

Precondition

The underbody protection of the steering gear is removed.

NOTE: TECHNICAL INFORMATION
When the screws are tightened, the cover can twist and cause scuff marks on the anti-roll bar (risk of corrosion).
Brace the cover while the screws are being tightened. Then check the position of the cover.

Position the cover (1) .

Tighten down screws (2) .

TIGHTENING TORQUE SPECIFICATION

Cover, steering unit
screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Position the cover (1) .

Tighten down screws (2) .

TIGHTENING TORQUE SPECIFICATION

Cover, steering unit
screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.