Install right rear upper seat belt
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Install rear upper seat belt
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Feed out the seat belt retractor (2) towards the rear.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Rear seat belt retractor to body M10
Replace screw.Tightening torque 42 Nm - Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE RIGHT FRONT LUGGAGE COMPARTMENT SIDE SHELF .
- Refer to INSTALLING RIGHT REAR LUGGAGE COMPARTMENT SIDE SHELF .
- Refer to INSTALLING THE CONTROL UNIT FOR THE TRAILER HITCH .
- Refer to INSTALLING THE RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING THE RIGHT REAR SEAT BELT END FITTING .
- Refer to INSTALLING THE REAR SEAT .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE RIGHT D-PILLAR TRIM PANEL .
- Refer to INSTALLING THE RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING LED IN LUGGAGE COMPARTMENT ON RIGHT .
- Refer to INSTALLING COVER FOR LUGGAGE COMPARTMENT ON RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE FRONT STORAGE SHELF .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .