Installing the flywheel

NOTE: TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure the centering hole (1) is on the centering pin (2) of the crankshaft.
Position flywheel.
Block the flywheel with special tools 0 494 129 (11 9 263) (1) and 0 493 938 (11 9 260) (2) and a transmission bolt M10x55 (3) .

Courtesy of BMW OF NORTH AMERICA, INC.

Replace screws (1) to (9) .
Parts: Screws
Tighten the screws (1) to (9) .

TIGHTENING TORQUE SPECIFICATIONS

Flywheel
Screw M12x1.5x28 Replace screws.	Joining torque	45 Nm
	Angle of rotation	45°

Fig 1: Flywheel Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Release and remove the transmission bolt (3) .
Remove special tools 0 494 129 (11 9 263) (1) and 0 493 938 (11 9 260) (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING AUTOMATIC TRANSMISSION (ALL-WHEEL DRIVE VEHICLE) (GA8HP76Z) .
Refer to INSTALLING THE TRANSFER BOX (ATC 13-1) .
Refer to INSTALLING FRONT PROPELLER SHAFT AT THE FRONT AXLE TRANSMISSION .
Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
Refer to INSTALLING THE RETAINING PLATES .
Refer to INSTALLING THE HEAT SHIELDS .
Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING EXHAUST SYSTEM .
Refer to INSTALLING CENTER STIFFENING PLATE .
Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
Refer to INSTALLING REAR BUMPER PANEL .
Refer to INSTALLING BOTH EXHAUST COVERS .
Refer to INSTALLING THE REAR BUMPER TRIM .
Refer to INSTALLING THE REAR DIFFUSER .
Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
Refer to INSTALLING LOADING EDGE TRIM .
Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
Refer to INSTALLING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to CONNECTING ALL BATTERY GROUND LEADS .