Installing the grooved ball bearing in the propeller shaft center bearing

• Lubricate the rubber-coated bearing carrier of the propeller shaft center bearing (1)  with lubricant.

  Consumable
  Installation aid  (Circo Light; lubricant)	250 ml, Bottle	83192405829

• Press in the grooved ball bearing using special tools 0 492 262 (33 3 202)  and 0 492 263 (33 3 203)  into the propeller shaft center bearing (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CENTRAL MOUNT OF THE PROP SHAFT .
• Refer to COMPLETELY INSTALLING THE PROP SHAFT (PLUG-IN - REAR FLEXIBLE DISC) .
• Refer to INSTALLING THE HEAT SHIELDS .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING CENTER STIFFENING PLATE .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING BOTH EXHAUST COVERS .
• Refer to INSTALLING THE REAR BUMPER TRIM .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .