Installing the centering for the propeller shaft

• Note the protrusion (A) at the centering (1).

  Protrusion (A) = 4+2 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove grease or water from mount bore.
• Drive centering (1) into the prop shaft using special tools 0 490 873 (11 2 350)  and 0 490 475 (00 5 500). When doing so, note the protrusion  ,

  Courtesy of BMW OF NORTH AMERICA, INC.

• Apply a thin coat of grease to the soft centering (1), if necessary.

  The hard centering (2) must not be greased.

  Consumable
  Lubricating grease Optitemp HT 1 LF	50 g, Tube	83230417754

  Consumable
  Lubricating grease Olistamoly 2 LN 584 LO	100 g, Tube	83 19 0 447 919

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to COMPLETELY INSTALLING THE PROP SHAFT (PLUG-IN - REAR FLEXIBLE DISC) .
• Refer to INSTALLING THE HEAT SHIELDS .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING CENTER STIFFENING PLATE .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING BOTH EXHAUST COVERS .
• Refer to INSTALLING THE REAR BUMPER TRIM .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .