Installing the centering for the propeller shaft
- Note the protrusion (A)
at the centering (1)
.
Protrusion (A) = 4+2 mm
- Remove grease or water from mount bore.
- Drive centering (1)
into the prop shaft using special tools 0 490 873 (11 2 350)
and 0 490 475 (00 5 500). When doing so, note the protrusion
,
- Apply a thin coat of grease to the soft centering (1)
, if necessary.
The hard centering (2) must not be greased.
Consumable Lubricating grease Optitemp HT 1 LF 50 g, Tube 83230417754 Consumable Lubricating grease Olistamoly 2 LN 584 LO 100 g, Tube 83 19 0 447 919
Follow-up work
- Refer to COMPLETELY INSTALLING THE PROP SHAFT (PLUG-IN - REAR FLEXIBLE DISC) .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to INSTALLING THE RETAINING PLATES .
- Refer to INSTALLING THE HEAT SHIELDS .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING REAR BUMPER PANEL .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to IF INSTALLED: INSTALLING THE REAR AXLE COVER .
- Refer to INSTALLING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
- Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING TRUNK COMPARTMENT LIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .