Installing the roller sunblind in the front
- Position roller sunblind in the front (1) on roller blind cover (2) .
- Ensure that guide pins (3) are positioned correctly.
- Tighten the screws (4)
.TIGHTENING TORQUES SPECIFICATION
Roller sunblinds on roller blind cover Screw tightening torque 3.5 Nm
Follow-up work
- Refer to INSTALLING THE ROLLING MODULE .
- Refer to PARTIALLY INSTALLING THE HEAD AIRBAG .
- Refer to CHECKING THE ROLLER SUNBLIND AND THE GLASS ROOF FOR FUNCTION .
- Refer to INSTALLING THE HEADLINING (LOWERED WITH PANORAMIC GLASS SUNROOF) .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING THE GRAB HANDLE AT THE REAR LEFT AND RIGHT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT VANITY MIRROR LIGHT .
- Refer to INSTALLING BOTH SUN VISORS AND COUNTER SUPPORTS .
- Refer to INSTALLING THE LEFT AND RIGHT HANDS-FREE MICROPHONE .
- Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING BOTH BACKREST SIDE SECTIONS .
- Refer to PARTIALLY INSTALLING BOTH B-PILLAR TRIM PANELS AT TOP .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to INITIALIZING PANORAMA GLASS ROOF .