Partially installing the head airbag
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
TECHNICAL INFORMATION
Notes on unlocking/locking airbag plug connections form the basis for these repair instructions and must be observed without fail.
For additional information see: UNLOCKING/LOCKING AIRBAG PLUG CONNECTIONS .
Notes on unlocking/locking airbag plug connections form the basis for these repair instructions and must be observed without fail.
For additional information see: UNLOCKING/LOCKING AIRBAG PLUG CONNECTIONS .
NOTE:
Perform the steps on the left and right side.
- Insert and position the gas generator (3).
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Head airbag to bodyshell | ||
|---|---|---|
| Screw | tightening torque | 8 Nm |
- Connect plug connection (1) and lock.
Activate electrical system
NOTE:
TECHNICAL INFORMATION
Follow the vehicle-specific instructions described in the additional information.
Follow the vehicle-specific instructions described in the additional information.
- Activate the vehicle electrical system as described in the additional information.