Install guide for rear center bumper
- Position the guide for the center rear bumper (1).
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (2).
- Tighten nuts (1).
TIGHTENING TORQUES SPECIFICATION
| Guide for rear bumper at center on body | ||
|---|---|---|
| Nut and washer assembly with paint scrape groove | Tightening torque | 5 Nm |
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Clip in clips (1).
- Clip in clamp (2).
- Clip in the connector housing (3).
- Clip in clamp (1).
- Clip in the clip (2).
Follow-up work
- Refer to INSTALLING THE GUIDE FOR REAR BUMPER COVER .
- Refer to IF INSTALLED: INSTALLING LANE CHANGE WARNING SENSOR .
- Refer to INSTALLING REAR PANEL .
- Refer to PARTIALLY INSTALLING THE REAR LEFT AND RIGHT WHEEL ARCH COVERS .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING BOTH SIDE REAR TRIM STRIPS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING BOTH LEDS IN THE CARGO AREA .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .