Installing rear panel
- Position rear bumper cover.
- Connect and lock the connector in the marked area.
- Clip in rear bumper cover with latch mechanisms (2) and (1).
- Clip rear bumper panel into latch mechanisms (arrows).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Front bumper panel to undershield | ||
|---|---|---|
| Thermoplastic hexagon screw | tightening torque | 3 Nm |
TIGHTENING TORQUES SPECIFICATION
| Bumper cover to guide, middle | ||
|---|---|---|
| Oval-head screw for thermoplastic | tightening torque | 3 Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Rear mount to bumper cover | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
Follow-up work
- Refer to PARTIALLY INSTALLING THE REAR LEFT AND RIGHT WHEEL ARCH COVERS .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING BOTH SIDE REAR TRIM STRIPS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING BOTH LEDS IN THE CARGO AREA .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .