Install the rear active stabilizer

• Position the active stabilizer (1)  .

  Guide the wiring harness outwards through the body and the rear axle support.

• Replace screws (2)  .

  Parts:  Screws

• Tighten down screws (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cable clip (2)  and ground strap on the right-hand retainer.
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING AND CONNECTING THE WIRING HARNESS OF THE ACTIVE STABILIZER IN THE REAR .
• Refer to SECURING THE LEFT AND RIGHT ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING BOTH EXHAUST COVERS .
• Refer to INSTALLING THE REAR BUMPER TRIM .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to IF INSTALLED: INSTALLING THE REAR AXLE COVER .
• Refer to INSTALLING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
• Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
• Refer to MOUNTING THE REAR RIGHT WHEEL .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
• Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING TRUNK COMPARTMENT LIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to FOR REPLACEMENT: PROGRAMMING/CODING THE ACTIVE STABILIZER .