Install and connect the wiring harness of the active stabilizer in the rear

Secure the wiring harness on holders (4) and (5).
Connect connectors (1) and lock.
Connect the connector (2) and secure the cable on the holder (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Fold the wheel arch trim panel (1) downwards.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten nuts (2).

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Wheel arch cover
Thermoplastic hexagon screw	Tightening torque	2.6 Nm
Plastic nut	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.