Install the rear active stabilizer

• Position the active stabilizer (1)  .

  Guide the wiring harness outwards through the body and the rear axle support.

• Replace screws (2)  .

  Parts:  Screws

• Tighten down screws (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cable clip (2)  and ground strap on the right-hand retainer.
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING AND CONNECTING THE WIRING HARNESS OF THE ACTIVE STABILIZER IN THE REAR .
• Refer to SECURING THE LEFT AND RIGHT ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING CENTER STIFFENING PLATE .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to INSTALLING REAR PANEL .
• Refer to PARTIALLY INSTALLING THE REAR LEFT AND RIGHT WHEEL ARCH COVERS .
• Refer to INSTALLING BOTH EXHAUST COVERS .
• Refer to INSTALLING BOTH SIDE REAR TRIM STRIPS .
• Refer to INSTALLING THE REAR BUMPER TRIM .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
• Refer to MOUNTING THE REAR RIGHT WHEEL .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
• Refer to INSTALLING BOTH LEDS IN THE CARGO AREA .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to FOR REPLACEMENT: PROGRAMMING/CODING THE ACTIVE STABILIZER .