Installing the hydraulic chain tensioner of cylinder bank 2
NOTE:
RISK OF DAMAGE
Damage to timing chain or timing chain drive .
Turning the engine without chain tensioner or special tool can result in damage to the timing chain and timing chain drive .
Damage to timing chain or timing chain drive .
Turning the engine without chain tensioner or special tool can result in damage to the timing chain and timing chain drive .
- Always turn the engine with the chain tensioner or the special tool.
- Feed in and position the hydraulic chain tensioner (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Chain tensioner to cylinder head screw Tightening torque 13 Nm - Remove the special tool 0 491 012 (11 4 120) or transportation retainer (3) from the bore.
Follow-up work
- Refer to INSTALLING TIMING CASE COVER AT TOP LEFT .
- Refer to INSTALLING THE IGNITION COIL OF CYLINDER 5 .
- Refer to INSTALLING THE VANOS SOLENOID ACTUATOR EXHAUST OF CYLINDER BANK 2 .
- Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT (CHARGE AIR COOLER) .
- Refer to SEALING OFF COOLANT FOR LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING FRONT STIFFENING PLATE AND/OR UNDERBODY PROTECTION OF THE STEERING GEAR .
- Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .