Install timing case cover at top left
TIGHTENING TORQUE SPECIFICATIONS
| Timing case cover on cylinder head | ||
| M6x20 screw | Tightening torque | 9.5 Nm |
- Position holder (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Fuel supply line to cylinder head cover/cylinder head | ||
| M6x16 | tightening torque | 10 Nm |
- Position union nut (2) and turn it a few times.
- Position screw (1) and turn it a few times.
- Tighten union nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Fuel delivery line to high pressure pump | ||
| M14 | Tightening torque | 30 Nm |
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Fuel supply line to cylinder head cover/cylinder head | ||
| M6x16 | tightening torque | 10 Nm |
- Replace sealing ring (1)
from the coolant pump (2)
.
Parts: Sealing ring
- Connect the coolant line (2) to the coolant pump.
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant line on coolant pump | ||
| Screw | tightening torque | 8 Nm |
Follow-up work
- INSTALLING THE IGNITION COIL OF CYLINDER 5 .
- INSTALLING THE VANOS SOLENOID ACTUATOR EXHAUST OF CYLINDER BANK 2 .
- INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT (CHARGE AIR COOLER) .
- SEALING OFF COOLANT FOR LOW-TEMPERATURE COOLANT CIRCUIT .
- INSTALLING FRONT STIFFENING PLATE AND/OR UNDERBODY PROTECTION OF THE STEERING GEAR .
- REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- INSTALLING FRONT UNDERBODY PROTECTION .
- CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- INSTALLING FAN COWL .
- INSTALLING THE REAR TOP CROSS CONNECTION .
- INSTALLING UPPER CROSS CONNECTION .
- INSTALLING BOTH FRONT-END STRUTS .
- INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .