Removing the support for the rear bumper cover
Preliminary work
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE LOADING EDGE TRIM .
- Refer to REMOVING BOTH LEDS FROM THE LUGGAGE COMPARTMENT .
- Refer to PARTIALLY REMOVING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to REMOVING THE COVER FOR THE WATER CHANNEL LEFT AND RIGHT .
- Refer to REMOVING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
- Refer to REMOVING REAR BUMPER TRIM .
- Refer to REMOVING BOTH REAR SIDE TRIM STRIPS .
- Refer to REMOVING BOTH EXHAUST COVERS .
- Refer to PARTIALLY REMOVING THE REAR LEFT AND RIGHT WHEEL ARCH COVERS .
- Refer to REMOVING REAR BUMPER PANEL .
- Refer to REMOVING THE BRACE FOR REAR BUMPER COVER .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- If installed:
- Release the left and right nut (1).
- Remove rear silencer with the bracket (2) downwards from the support for rear bumper cover.
- Loosen nuts (1).
- Remove the support for the rear bumper cover (2).