Install lock for rear seat backrest

• Position lock for the backrest covering (2) correctly.
  NOTE: Carefully open up backrest cover for adaptation of the lock of the backrest covering, so that the correction installation position can be determined.
• Tighten down screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position Bowden cable (1) correctly in the lock for the backrest covering (2) and mount it carefully.
• Correctly position and clip in the Bowden cable bracket (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE STORAGE SHELF .
• Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
• Refer to INSTALLING BOTH REAR SIDE TRIM PANELS .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .