Replacing the LED module on the center console
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE REAR CENTER CONSOLE TRIM .
- Refer to REMOVING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to REMOVING CENTER ARMREST .
- Refer to REMOVING THE SPEAKER TRIM AT THE DASHBOARD .
- Refer to REMOVING CENTRAL INFORMATION DISPLAY (CID) .
- Refer to REMOVING CUP HOLDER .
- Refer to REMOVING THE WIRELESS CHARGING STORAGE .
- Refer to REMOVING THE CENTER STACK MODULE .
- Refer to REMOVING THE LED MODULE ON THE CENTER CONSOLE .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Release the locking mechanism (1)
and thread the LED module together with the fiber optic cable (2)
out of the bracket (3)
.
- Expand the guides of the LED module (1)
and remove the LED module from the fiber optic cable (2)
.
- Replace the LED module (2)
.
Parts: LED module
- Correctly position the LED module (2)
and attach it to the fiber-optic cable (1)
.
- Insert the LED module with fiber optic cable (2)
in the holder (3)
and snap into the lock (1)
.
Follow-up work
- Refer to INSTALLING THE LED MODULE ON THE CENTER CONSOLE .
- Refer to INSTALLING THE CENTER STACK MODULE .
- Refer to INSTALLING THE WIRELESS CHARGING STORAGE .
- Refer to INSTALLING THE CUP HOLDER .
- Refer to INSTALLING THE CENTRAL INFORMATION DISPLAY (CID) .
- Refer to INSTALLING THE SPEAKER TRIM AT THE DASHBOARD .
- Refer to INSTALLING CENTER ARMREST .
- Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .