Removing the engine wiring harness section/DME
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE COVER PANEL OF THE LEFT DME CONTROL UNIT .
- Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to REMOVING BOTH FRONT-END STRUTS .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE CONTROL UNIT BRACKET FOR CYLINDERS 5 TO 8 .
- Refer to REMOVING FAN COWL .
- Refer to PARTIALLY RELEASING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to REMOVING DRIVE BELT .
- Refer to REMOVING THE RIGHT HAND FRONT BOTTOM SIDE COVER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- Refer to REMOVING THE FRONT THRUST FIELD OR THE UNDERBODY PROTECTION OF THE STEERING GEAR .
- Refer to DRAINING COOLANT .
- Refer to PARTIALLY RELEASING THE RIGHT CHARGE AIR LINE .
- Refer to RELEASING LEFT CHARGE AIR LINE PARTIALLY .
- Refer to PARTIALLY REMOVING THE CHARGE AIR COOLER .
- Refer to REMOVING THE CLEAN AIR PIPE OF CYLINDER BANK 1 .
- Refer to REMOVING THE CLEAN AIR PIPE OF CYLINDER BANK 2 .
- Refer to DISCONNECTING THE COOLANT LINES OF THE EXHAUST TURBOCHARGER .
- Refer to REMOVING THE ALTERNATOR .
Overview graphic of the wiring harness section for the engine/DME
- Unlock and disconnect plug connections (1).
- Release the wiring harness mountings (2).
- Loosen clip (1).
- Loosen nut (2).
- Remove the eyelet (3).
- Unclip the wiring harness (2) in area of holder (1).
- Release the wiring harness mountings (1).
- Loosen screw (2).
- Remove the eyelet (4).
- Feed out the wiring harness (3) and remove.