Remove fan cowl
Preliminary work
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING BOTH HEADLIGHTS .
- Refer to REMOVING THE CENTER TOP CROSS CONNECTION .
- Refer to REMOVING THE FANFARE HORN ON THE LEFT .
- Refer to REMOVING THE FANFARE HORN TOWARDS THE RIGHT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE LEFT-HAND AIR DUCT .
- Refer to REMOVING RIGHT AIR DUCT .
- Refer to REMOVING LEFT INTAKE PORT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
Precondition
Ignition is switched off.
- Loosen the coolant lines (1) from the fan cowl.
- Unlock the clamps (2) and (3) and loosen the coolant lines from the fan cowl.
- Loosen screws (1).
- Unlock connector (2) and detach.
- Guide out fan cowl (1) in arrow direction and remove.