Installing the Y-cable

• Position the Y-cable (2) as shown.
• Attach the Y-cable (arrow).
• Tighten down screw (1).

• Close the plug connection (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CLEANING THE SEALING SURFACES (INSTALLATION OF THE REMOVED COVER OF THE EME) .
• Refer to INSTALLING HIGH-VOLTAGE CONNECTION .
• Refer to INSTALLING THE REMOVED EME .
• Refer to CLEANING SEALING SURFACES .
• Refer to INSTALLING THE LID OF ELECTRICAL MACHINE ELECTRONICS .
• Refer to CHECKING THE TIGHTNESS OF THE COOLANT CIRCUIT OF THE ELECTRIC DRIVE UNIT .
• Refer to INSTALLING THE COOLANT LINES .
• Refer to EXECUTING FUNCTIONAL CHECKING BEFORE RE-INSTALLATION .
• Refer to REMOVING THE PRESSURE COMPENSATION ELEMENT FROM EME LID .
• Refer to REMOVING THE PRESSURE COMPENSATION ELEMENT FROM THE LID OF THE BRUSH COMPARTMENT .
• Refer to PERFORM EOS TEST .
• Refer to STICKING THE PRESSURE COMPENSATION ELEMENT ON THE LID OF THE BRUSH COMPARTMENT .
• Refer to STICKING THE PRESSURE COMPENSATION ELEMENT ON THE EME LID .
• Refer to REMOVING THE ELECTRICAL DRIVE UNIT FROM THE ASSEMBLY JIG .
• Refer to INSTALLING REAR SOUND INSULATION .
• Refer to INSTALLING THE ELECTRIC DRIVE UNIT IN THE REAR AXLE SUPPORT .
• Refer to INSTALLING THE TOP SOUND INSULATION .
• Refer to INSTALLING THE WIRING HARNESS MOUNTING .
• Refer to INSTALLING THE RIGHT POTENTIAL EQUALIZATION LINE .
• Refer to REMOVING THE MOBILE LIFTING TABLE .
• Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
• Refer to FASTENING THE RIGHT AND LEFT OUTPUT SHAFTS ONTO THE WHEEL BEARING .
• Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to MEASURING THE RIDE HEIGHT OF THE REAR AXLE AND SETTING THE NORMAL POSITION .
• Refer to PERFORM CHASSIS ALIGNMENT CHECK .
• Refer to DELETE FAULT MEMORY .
• Refer to CALIBRATING AND TEACHING IN THE ROTOR POSITION SENSOR .