Removing cross member
Preliminary work
- Refer to REMOVING THE BELLOWS FOR THE GLASS SLIDE/TILT SUNROOF .
- Refer to REMOVING GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to REMOVING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to REMOVING THE SUN VISORS AND THE LEFT AND RIGHT COUNTER SUPPORTS .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING INTERIOR ROOF LIGHT .
- Refer to REMOVING THE LEFT AND RIGHT B-PILLAR TRIM PANELS PARTIALLY .
- Refer to REMOVING THE REAR LEFT AND RIGHT HANDLE .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING REAR WINDOW STORAGE SHELF AT FRONT .
- Refer to REMOVING THE COVER OF THE LEFT AND RIGHT LUGGAGE COMPARTMENT SIDE SHELF .
- Refer to REMOVING THE LEFT AND RIGHT D-PILLAR TRIM PANEL .
- Refer to LOWERING THE HEADLINING (WITH SLIDING/TILTING SUNROOF) .
- Refer to REMOVING SLIDE/TILT SUNROOF COMPLETELY .
NOTE:
Perform the steps on the right and left side.
- Mark the position of the cross-member (4) on the slide/tilt sunroof frame.
- Loosen nuts (1) .
- Remove the lock washer (2) and guide out the screw (3) .
- Remove the cross-member (4) .